2002-2004 Isuzu Axiom A/T – Shift Lock Solenoid Replacement
download TSB SB05-05-5004 Shift Lock Solenoid ISSUE DATE: MAY 2005 Affected Vehicles 2002-2004 Isuzu Axiom (UP) 1998-2004 Isuzu Rodeo (UE) and Rodeo Sport (UA) Service Information Use the following...
View Article2000 Hyundai Accent L Hatch Back Cylinder Head Assembly Removal and Installation
download 1. 2. 3. 4. 5. Drain the coolant and disconnect the upper radiator hose. Remove the breather hose (between the air cleaner and the rocker cover). Remove the air-intake hose. Remove the vacuum...
View Article1998 Volvo S70 Trunk/ Liftgate Lock Cylinder
download Replacing Trunk Lid Lock Unit, Switch or Motor (4-Door) ZZB1. Removing trunk lid lock unit (4-door) Remove lock unit, See below CA5. ZZB2. Installing trunk lid lock unit (4-door) Install lock...
View Article2000 Ford F-Super Duty 250-550 Clutch Master Cylinder and Reservoir REMOVAL...
download Removal CAUTION: Remove the entire clutch hydraulic system from the vehicle as an assembly when installing a new clutch master cylinder assembly (7C522). 1. Disconnect the clutch hydraulic...
View Article1998 Ford Mustang Steering Column Disassembly Assembly
download 1. Disconnect battery ground cable (14301) . Refer to Section 14-01. 2. Remove steering wheel (3600) as described. 3. Remove steering column from vehicle as described. 4. Remove steering...
View Article2007 Chevrolet HHR Power Door Locks Inoperative Diagnostic
download Power Door Locks Inoperative Diagnostic Instructions • Perform the Diagnostic System Check – Vehicle prior to using this diagnostic procedure. • Review Strategy Based Diagnosis for an overview...
View Article2006-2009 Hyundai Accent 2006-2009 Kia Rio Dash Disassembly
download 1 Disconnect the negative battery terminal to prevent an accidental short circuit. 2 Unclip and remove the trim panel surrounding the radio and includ- ing the a/c vents. (Figure A) 3 Remove...
View Article1997 Toyota Camry LE Sedan 4-Door Cylinder Head Installation
download 1. Install cylinder head. A. Place cylinder head on cylinder block. (a) Place a new cylinder head gasket on the cylinder block. CAUTION: Be careful of the installation direction. (b) Place the...
View Article1993 Ford Ranger Ignition Lock: Service and Repair With Key
download The following procedure applies to vehicles that have functional lock cylinders, ignition keys available for the vehicle, or ignition key numbers that are known and the proper key can be made....
View Article2001 Ford F-150 Clutch Master Cylinder/ Reservoir REMOVAL AND INSTALLATION
download Removal NOTE: When replacing clutch master cylinder (7A543), remove tubing from vehicle for bench bleeding procedure. 1. Disconnect the clutch master cylinder push rod from the clutch and...
View Article
